Masterpage:Right+
EN
55
Filename [M150SEK_09Editing.fm]
EDITING
You can use a camcorder as the source player and your unit as the
recording deck.
1
Make connections.
A
If the camcorder has no S-VIDEO output connector:
^
connect the camcorder’s AUDIO/VIDEO OUT connectors to
the unit’s [VIDEO/AUDIO (L(MONO)/R)] input connectors on
the front panel.
●
When using a monaural camcorder, connect its AUDIO OUT
connector to the [AUDIO (L(MONO))] input connector on your
unit.
B
If the camcorder has an S-VIDEO output connector:
^
connect the camcorder’s AUDIO OUT and S-VIDEO OUT
connectors to the unit’s [AUDIO (L(MONO)/R)] and
[S-VIDEO] input connectors on the front panel.
2
Press
PR +/–
to select
A
F-1
B
.
●
Set
A
F-1 INPUT
B
to
A
VIDEO
B
for the [VIDEO] input connector, or
A
S-VIDEO
B
for the [S-VIDEO] input connector, depending on the
connector being used. (
A
pg. 58)
3
Press
REC MODE
repeatedly to set the recording mode.
4
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
5
Press
R
on the unit to start recording. Or while holding
R
, press
I
on the remote control. The dubbing starts.
6
Upon completing dubbing, stop the unit and the camcorder.
●
Stop recording on the recording deck (your unit), then stop
playback on the source player (camcorder).
NOTES:
●
All necessary cables can be obtained from your dealer.
●
Refer to the camcorder’s instruction manual for operating
procedure.
●
The quality of the dubbed picture is poorer than that of the
original.
Edit From A Camcorder
RAM/RW
A
If the camcorder has no S-VIDEO output connector:
Recorder
Player
To [VIDEO/AUDIO
(L(MONO)/R)] input
Audio/video cable
(not supplied)
AUDIO/VIDEO OUT
RAM/RW
B
If the camcorder has an S-VIDEO output connector:
To [S-VIDEO]
input
To [AUDIO]
input
S-video cable
(not supplied)
AUDIO OUT
Audio cable
(not supplied)
S-VIDEO OUT
Recorder
Player
M150SEK_00.book Page 55 Wednesday, June 15, 2005 4:04 PM