Juniper NetScreen-5000 Series, Руководство по установке и настройке

Страница: 41 / 68

Configuring Aggregate Interfaces
„ 41
Configuring the Device
Configuring Aggregate Interfaces
The NetScreen-5000 Series system allows you to combine two or more physical
ports on an SPM into a single virtual port. This virtual port is known as an
aggregate
interface . Only Secure Port Modules (SPMs) support this feature. Table 8 describes
the aggregate interfaces supported on the various SPMs.
You assign the aggregate interface a name of the format aggregate1 through
aggregate
n
, where n is the total of the maximum number of aggregate interfaces
supported by all of the SPMs in the chassis.
In the following example, you combine two SFP ports, each running at 1 Gbps, into
an aggregate interface running at 2 Gbps. The aggregate interface consists of
Ethernet ports 1 and 2 on a 5000-8G SPM (residing in slot 2).
To create the aggregate interface:
1. (Optional) To see what physical ports are available on your NetScreen-5000
Series system:
get interface
2. To create an aggregate interface name:
set interface
string
zone
zonename
where string is a legal aggregate interface name.
For example, to create the aggregate interface name aggregate1 :
set interface aggregate1 zone zonename
3. To assign ports ethernet2/1 and ethernet2/2 to the aggregate1 interface name:
Table 8: Aggregate Interface Support per SPM
SPM Type Maximum
number of
aggregate
interfaces Maximum
number of ports
per aggregate
interface Supported Aggregations
5000-8G 4 2 Only the following port combinations:
1 and 2
3 and 4
5 and 6
7 and 8
5000-8G2 and
5000-8G2-G4 4 4 Any combination of ports 1 through 4, or
any combination of ports 5 through 8. You
cannot aggregate ports 1 through 4 with
ports 5 through 8.
5000-2G24FE 6 (5 for FE
ports and 1
for SFP ports) 8 Any combination of up to 8 FE ports per
aggregate interface. You can also aggregate
the two SFP ports together. You cannot
aggregate FE ports and SFP ports together.