Juniper NetScreen-5000 Series, Руководство по установке и настройке

Страница: 34 / 68

NetScreen-5000 Series Hardware Installation and Configuration Guide
34 „
Performing Initial Connection and Configuration
Figure 17: Console Connection, NetScreen-5200 (NetScreen-5400 Similar)
3. Launch a CLI session between your workstation and the NetScreen-5000 Series
system using a standard serial terminal emulation program such as Hilgraeve
HyperTerminal (provided with the Microsoft Windows operating system). The
settings should be as follows:
„ Baud Rate to 9600
„
Parity to No
„ Data Bits to 8
„ Stop Bit to 1
„ Flow Control to none
4. At the HyperTerminal window, press Enter to display the login prompt.
5. At the login prompt, enter netscreen .
6. At the password prompt, enter netscreen .
7. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To change this timeout interval, use the following
command:
set console timeout number
where number is the length of idle time in minutes before session termination.
To prevent any automatic termination, specify a value of 0 .
NOTE:
Use lowercase letters only. The username and password are both case-sensitive.