Juniper JUNOSE 11.0, Справочник по командам

Страница: 219 / 1486

atm oam
Syntax
atm oam [ vpi ] [ [ seg-loopback | end-loopback [ loopback-timer time ] ]
[ cc { source | sink | both } ] ]
no atm oam [ vpi ] [ [ seg-loopback | end-loopback [ loopback-timer time ] ] ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Configures F4 OAM on an interface or circuit. The no version deletes F4 OAM circuits.
NOTE: If you do not specify any options, both F4 end-to-end OAM and F4 segment
OAM are enabled on all VPIs on the interface.
Options
■
vpi —VPI on which you want to enable F4 OAM. If you do not specify a VPI, F4
OAM flow is enabled on all VPIs on the interface.
■
seg-loopback—Enables F4 segment OAM
■
end-loopback—Enables F4 end-to-end OAM
■
loopback-timer—To generate F4 loopback cells on the VPI, you must configure
the loopback timer; you can set the loopback timer only for end-to-end loopback
■
time —Time interval in the range 1–600 seconds between transmissions of F4
loopback cells.
■
cc—Enables CC cells on the PVC; you can enable CC cells only on data circuits,
not on control circuits, such as ILMI or signaling circuits
■
sink—Enables this VC as a sink point (cell receiver)
■
source—Enables this VC as the source point (cell generator)
■
both—Enables this VC as both a sink point and a source point
Mode
Interface Configuration, Subinterface Configuration
atm oam
■ 177
Chapter 2: A Commands