Juniper JUNOSE 11.0, Справочник по командам

Страница: 1131 / 1486

ipv6 prefix-list
Syntax
ipv6 prefix-list listName { description desc | { [ seq sequence ] { permit | deny }
ipv6Prefix [ ge geNumber ] [ le leNumber ] } }
no ipv6 prefix-list listName [ description | [ seq sequence ] [ { permit | deny }
ipv6Prefix [ ge geNumber ] [ le leNumber ] ] ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Creates an IPv6 prefix list for route filtering; specifies a list entry—a permit or deny
clause for a network address. The
no version removes the specified prefix list or the
specified list entry.
Options
■
listName —Name of the IPv6 prefix list; a string of up to 32 characters
■
desc —Description of the prefix list
■
sequence—Number in the range 0–65535 that indicates the position the prefix
list entry has in the already existing list of entries for the prefix list; if you do not
specify a
sequence , the command uses the value of the last sequence
5
■
permit—When specified, the router redistributes any prefix that matches the
filtered route based on the set actions
■
deny—When specified, the router drops any prefix that matches the filtered
route
■
ipv6Prefix —Network route that you want to filter, in the format ipv6Address /
length , where
■
ipv6Address— Base IPv6 address of the network route that you want to filter
(for example, ::ffff:a:b:c:d)
■
length —Length of the network prefix; number of bits masking base address
to produce address to be matched
■
geNumber —Route being filtered matches if its prefix is within the range specified:
greater than or equal to geNumber and less than or equal to 32
■
leNumber —Route being filtered matches if its prefix is within the range specified:
greater than or equal to length and less than or equal to leNumber
Mode
Global Configuration
ipv6 prefix-list
■ 1089
Chapter 10: I Commands