Juniper JUNOSE 11.0, Справочник по командам

Страница: 1411 / 1486

mpls policy
Syntax
mpls policy { input | output } policyName
[ statistics { enabled [ baseline { enabled | disabled } ] [ preserve | merge ] |
disabled [ merge ] } | merge ]
no mpls policy { input | output } [ policyName ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
merge keyword added in JUNOSe Release 7.2.0.
Description
Assigns a policy list to the ingress or egress of an MPLS layer 2 transport interface.
If you enter this command when the policy list does not exist, the router will create
a policy list with a filter rule as the default. Attaching this policy list to an interface
filters all packets on that interface. You must specify the
input or output keyword
to assign the policy list to the ingress or egress of the interface. The no version
removes the association between a policy list and an interface.
Options
■
input—Applies policy to data arriving at this interface
■
output—Applies policy to data leaving this interface
■
policyName —Name of the policy; a maximum of 40 characters
■
statistics—Enables or disables collection of policy routing statistics
■
enabled—Enables collection of policy routing statistics
■
baseline enabled—Enables baselining of policy routing statistics
■
baseline disabled—Disables baselining of policy routing statistics
■
preserve—Preserves existing statistics for any classifier-list that is the same
for both the new and old policy attachments when you attach a new policy
to an interface
■
disabled—Disables collection of policy routing statistics
■
merge—Enables merging of multiple policies to form a single policy
Mode
Interface Configuration
Related Topics
Configuring HDLC Layer 2 Services in the JUNOSe BGP and MPLS Configuration
Guide
■
■
Setting a Statistics Baseline for Policies
mpls policy
■ 1369
Chapter 13: M Commands