A-29 Super Tucano 60TP 1.1 2022
7
Specifications:
Wingspan:
2800 mm
Length:
2630 mm
Wing Area:
96,93 dm
2
Wing Loading:
175 g/dm
2
to 185 g/dm
2
Spinner:
4
3/4“ (120 mm)
Turbines:
Kingtech G-60TP
Weight:
approx. 10 Kg Flying weight: 20 to 21 Kg (depends on installed accessories).
Radio:
9 channels minimum for limited installation. 12 or more channels for complete installation (not
included).
Servos:
4 standard size servos (15kg-cm or more torque), 3 standard size servos 20 kg-cm or more torque and
from 1 to 3 standard size servos (4 kg-cm 56,8oz-in or more torque). All servos must be metal geared.
Fuselage Junction
The fuselage is supplied in 2 sections that must be united together with 30 to 40 minutes epoxy glue and 6
screws with washers to get permanently glued and assembled in 1 piece.
IMPORTANT:
WE DO NOT RECOMMEND ASSEMBLING OR USING YOUR MODEL AIRPLANE WITH THE FUSELAGE
JUST SCREWED FOR ASSEMBLING AND DISASSEMBLY.
The 1/4” blind nuts are already instal
led in the rear fuselage section. Test the union of the 2 parts and check
the perfect fit between them. Sand the parts to be glued with 120 to 150 grit sandpaper to increase the adhesion
of the glue. Apply epoxy glue to the front section of the fuselage across the area to be glued, then join the parts
together. Apply high grade (permanent) threadlocker to the threads of the 6 1/4" x 3/4" allen screws (supplied
with the kit) and insert them with the 6 1/4" washers through the front section of the fuselage tightening until
are very firm, thus achieving perfect alignment of the fuselage. Remove excessive glue with a cloth soaked in
alcohol and wait for the glue to cure completely.
X 6
Above: application of epoxy glue on the front section of the fuselage (left), parts joined with screws and
washers in the final location (center) and 1/4" x 3/4" allen screw with 1/4" washer to be used ( right).
