A-29 Super Tucano 60TP 1.1 2022
43
Front landing gear landing lights LEDs:
2 LEDs top 5mm, white light, 11.000K, power 3W.
Dorsal fuselage beacon LEDs:
2 5mm hat type LEDs, red light, 11.000K, power 1/2W.
Fuselage´s interception headlight LED:
1 LED, White light, 11.000k, power 3W, with lens.
Vertical stabilizer formation lights LEDs:
2 LEDs, White light, 11.000K, power 1W.
It is recommended to disconnect the battery from the circuit when not using the model aircraft for more
than 5 days.
It is necessary to connect the circuit to a receiver channel controlLED by a 3-position switch on the radio.
When the system is connected to the battery, the circuit performs a self-test by turning on all the lights for 1
second, indicating its perfect functioning. The radio control switch in the maximum position turns on the circuit,
turning on all the lights (fixed and flashing), in the middle position, it turns off only the landing lights and keeps
the navigation lights on and in the minimum position turns off the circuit, turning off all the lights.
Note that the boards are labeLED on the right (green light) and on the left (red light). To pass the lighting kit
wires inside the wing, position it with the tip up and insert a thread with a weight tied to the tip through the
hole in the wing tip until it comes out through the front hole in the wing root. Tie the connector of the wing
light extension to the end of the thread at the end of the wing and carefully pull the connector to the root of
the wing, leaving the light board of the wing tip on the outside. With a 90º bent wire, pull the wires from the
landing light board through the opening in the leading edge of the wing and pull the plate to the outside. Repeat
the same process for the other half of the wing.
Above: weight on thread tip to pass the wires and wire to pull the wing landing light boards.
To fix the main board on the model airplane, the boards on the wing tips, landing lights and rudder board,
use 3M high-adhesion double-sided tape (red). Before gluing the tapes, apply 3M 8250 adhesion promoting
primer to the contact surfaces for a good result.
Above: locais corretos de fixação das placas de luz de ponta de asa (left) e faróis (right).
