A-29 Super Tucano 60TP 1.1 2022
36
The approximate consumption of the retractable system is 200mAh per retract/extend cycle. Thus, a
2000mAh battery is capable of retracting and extending the retractable fully 10 times, approximately, under
normal operating conditions.
VERY IMPORTANT: Landing gear door servos should be high voltage (7,4V). Check the proper voltage for both
the controller and the servos used.
It is necessary to connect the electronic controller to a designated receiver channel to control the landing
gear position (extended or retracted) via standard 3-way servo plug (+ / - / signal). The channel assigned to the
retracts command must be set to 100% travel (EPA or ATV) in both positions.
Retract set operation sequence with the V-1 controller option:
1) Turn on radio and receiver setting EPA or ATV to 100% in both switch positions.
2) Plug the 7,4V 2S Li-Po battery to the controller by the JST plug.
3) Set the retracts switch to close retracts. The controller will retract the landing gears and then close the gear
door.
4) Move the retracts switch to open position. The controller will open the gear door, then open the landing
gears.
Full set content:
2x metal struts for main gear equipped with 4 1/2" wheels and brake system
1x metal strut for front landing front equipped with 75 mm wheel and pull-pull arms
2x JP Hobby ER-200 85° retracts actuators on bases (up to 25kg/low assembly/internal actuator)
1x JP Hobby ER-200 100° retract actuator on base (up to 25kg/ low assembly/internal actuator)
1 JP Hobby ER-200 V1 controller. Gear doors and brakes integrated commands
Above: JP ER-200 V1 controller with brakes showing retracts connections on upper side and brakes outputs on
lower side (left photo). JST plugs (male and female) and the 2 standard 3-way servo plugs for retracts and
brakes signal (center). Power wire (red and black) retracts radio signal wire (yellow, red and brown), brakes
radio signal wire (red, black and white) and gear doors servos connections (right photo).
