A-29 Super Tucano 60TP 1.1 2022
27
Above: short screwdriver and correct position to screw the wing´s servos.
Above: aileron and flaps horns gluing process. Open slots (left), horns position with instalLED linkage (center)
and glued horns on aileron command surface (right).
To assemble the two wing halves in the fuselage,
2 32mm external diameter x 3mm thickness x 532mm
long
carbon fiber
tubes
are used. The wing / fuselage set is pre-adjusted at the factory and uses 4 allen screws
1/4 "x 3/4" and 4 washers 1/4" (supplied with the kit), 2 screws with washers on each side. Insert the tubes into
the fuselage until centered. The wing halves has 3 holes in the root, the front hole to allow passage for ailerons
and flaps servo extensions and lights into the fuselage, the central hole where the tube must be inserted and
the rear hole for servos and retracts extensions. At the rear there is a pin made of 1"diameter aluminum tube
to align the wing halves at their correct angle of incidence (+2 degrees). The drawing below shows the position
of the 3 holes and pin. Insert the halves, check that the roots of the wing are perfectly aligned with the shape
of the wing in the fuselage. Insert the screws with washers into the holes in the lower part of the wing halves in
the holes identified below by the letters X and tighten them until they are tight. We recommend the use of a
medium-grade (removable) thread lock.
X 4
