A-29 Super Tucano 60TP 1.1 2022
28
IMPORTANT: THE WING FIXING SCREWS MUST BE INSERTED OUT OF THE FUSELAGE TO THE INSIDE AND
NEVER FROM INSIDE TO OUTSIDE.
Elevators:
4 simple horns needed, 30mm to 40mm tall. Servo arms 40mm to 45mm from center to the end.
Horn reinforcements measure 50mm x 50mm. The servos must be screwed directly into the ribs inside the
stabilizer according to photos, which are previously drilLED. Before definitively screwing the servos, apply a
drop of medium CA glue or 5 minutes epoxy glue to each hole. It is necessary to open a slot in the roots of the
stabilizer for the passage of the servo arms as shown in the photos. To fix the servo compartment covers apply
a drop of medium CA glue or 5 minutes epoxy glue in each hole for better fixation and resistance to vibration.
Recommended deflection: Between 27mm (low rate) to 35mm (high rate) - up and down. To measure the
deflection, place a ruler at the end of the control surface and move it.
Above: elevator servo compartment access cover location (left) and servo fixation rib (right).
