![JuniAer A-29 Super Tucano 60TP Скачать руководство пользователя страница 44](http://html1.mh-extra.com/html/juniaer/a-29-super-tucano-60tp/a-29-super-tucano-60tp_assembly-and-instruction-manual_2032091044.webp)
A-29 Super Tucano 60TP 1.1 2022
44
The clear parts for navigation lights and wing landing lights are supplied in a thermoformed set. Cut out the
parts of the set with very sharp scissors and then remove the back and sides following the embossed reference
line. With a 280 to 320 fine grit sandpaper, finish the cut parts, sand the inner ends of the clear parts without
excess and in the places of the wing where the parts will be glued for better adhesion. Note that there are 2
right parts and 2 left parts. To glue after installing the light kit, use white canopy glue and attach the clear parts
with good adhesion masking tape, allowing to cure for 12 hours. After curing, remove the tapes and clean any
tape or glue residue. We recommend ZAP Formula 560 (PT-56). Never use CC glue to glue these parts, as the
evaporated gases stain and damage the clear plastic material.
Above: parts cut from set. Above: desired parts shape.
Above: clear plastic part glued at correct place.
To install the 2 red LEDs board of the beacon on the fuselage back, it is necessary to remove the 2 replicas of
the LEDs and make 2 holes with a 5mm drill. Insert the board from the inside of the fuselage and test the
accommodation of the LEDs. Apply 5 to 10 minutes epoxy glue in the contact area of the board with the fuselage
and place it in the final position until the glue has completely cured. The 2 red LEDs must be exposed on the
outside of the fuselage.
Above:
position of the LED replicas on the fuselage back that must be cut and drilLED with a 5mm drill.