Jungheinrich DFG 425s, Руководство по эксплуатации

Страница: 223 / 229

03.13 EN
222
6 Check load chain setting and tension if necessary.
t
7 Check load chain lubrication and lubricate if necessary.
t
8
Check lateral clearance of the mast connections and the fork
carriage.
t
9
Visually inspect the mast rollers and check contact surface wear
level.
t
10
Check running surfaces of the mast for wear and damage, and
lubricate if necessary.
t
11 Test hydraulic system.
t
12 Replace the hydraulic reservoir discharge lid.
t
13 Replace hydraulic oil filter.
t
14
Check that hydraulic ports, hose and pipe lines are secure, check for
leaks and damage.
t
15 Test emergency lowering system.
t
16 Check hydraulic oil level and top up if necessary.
t
17 Test relief valve and adjust if necessary.
t
18 Replace hydraulic oil.
t
19 Check forks or load handler for wear and damage.
t
20
Check piston rod screw depth and counter fixing / clamp. Where two
tilt cylinders with the same stroke length are used, check the setting
in respective of each other.
t
21 Check tilt cylinders and mounting.
t
22 Test lift and lowering speeds.
t
Agreed performance levels W A B C
1
Carry out a test run with rated load, if necessary with a customer-
specific load.
t
2 Lubricate truck according to the lubrication schedule.
t
3 Demonstration after servicing.
t
Steering W A B C
1 Test hydraulic steering and its components.
t
2 Test the hydraulic steering for leaks.
t
3 Check steering hoses and lines.
t
4 Check steering axle and steering knuckle for wear and damage.
t
5 Check stub axle and adjust if necessary.
t
6 Grease the steering axle.
t
7 Check mechanical parts of steering column.
t
Hydraulic operations W A B C