EN
64
Operating Manual: FRWM200 – Smoke Alarm Device with Radio Link
9.2 Shared group connecting test
You can check the correct connection of a
radio group to a shared radio group, only on
devices in a subgroup, as follows:
(1)
Press and hold testing / stop button of
any device of the subgroup pressed for
approx. 60 seconds.
After approx. 1 second, the test
tone will sound.
After approx. 12 seconds, and
after 60 seconds, the test tone
sounds again.
(2)
Release testing / stop button.
All devices in the shared radio
group emit a short test tone.
(3)
Repeat the process, if necessary, on
further subgroups.
5
Successful connection test of the
shared radio group.
In the following situations, you must restore the
factory settings:
•
Connection attempt was unsuc-
cessful and must be repeated
•
To remove the allocation of a device
to a radio group, e.g. defective device
Proceed as follows:
(1)
Pull out activation button.
(2)
Press and hold the testing / stop button
for approx. 2 to 3 seconds and then
release.
(3)
Press the radio button using a split pin
until the signal LED starts to flash yellow.
(4)
Release radio button immediately.
5
The device is in the factory state.
10 Restoring factory
defaults
