Joyner JNSZ1600DL, Руководство пользователя

Страница: 14 / 138

13
SERVICE INSTRUCTIONS
a. Put the vehicle on the level ground.
b. Shut down the engine, put a collecting oil plate under the transmission oil outlet. Loosen the oil
outlet plug in the warm engine. Let the transmission oil out fully
(see Fig. 14
、
15).
c. Remove the iron dust plug, this plug has a magnet on it. Iron dust caused by moving parts will
stick to the plug. Clean the iron dust from this dust plug
(see Fig. 16) .
d. Tighten the transmission oil outlet plug and the iron dust plug (see Fig. 16) .
e. Remove the plug (see Fig. 13), fill oil (API 80(75) W-90 GL-3 Gear Oil ) about 2.0 liters.
Check transmission oil
If the color of transmission oil changes, you need to replace oil. Replace transmission
oil as above.
D. Engine Coolant
You must check the coolant for level and leaks. If it is low, you need to refill coolant into the radiator
(
approximately 6000 ml ). The lack of coolant will cause the engine to overheat. This can cause engine
damage.
The coolant should always be topped up, since the coolant can evaporate.
Figure 18
Figure 19
Put the vehicle on level ground.
1.
Turn the coolant cap counterclockwise and open the cap (see Fig. 16) .
2. Pour fresh coolant to filler neck.
3. Start the engine at idle.