Joyner JNSZ1600DL, Руководство пользователя

Страница: 83 / 138

92
——The left chart is QDY1258
——When checking starter, you should clean carbon brush. Its surface should not have dust and calibrator,
and the brush can move freely in the carbon brush carrier. Change them if the brush and carrier are
damaged severely.
——Clean the commutator’s surface with clean cloth. And engage the commutator if its surface is not
smooth and round. ——As assembling carbon brush, make sure the brush spring is pressed on the brush
correctly.
——Pay more attention to keep the wire bayonet clip clean. Make sure there’s no oil fouling and water. Or
the voltage drop is too high, and the engine doesn’t work.
3. Spark plug. Type: K7RTC Tighten torque: 17.0-33.0Nm
4.
Ignition controller Type: ZJ5701F-HB or KH-3A.
5.
Breakerless distributor Type: FDW451 (with ZJ5701F-HB Ignition controller) or JFD459 (with
KH-3A Ignition controller)
Removing: ——Turn the crankshaft to cylinder 1’s TDC.
——Before removing, check and make sure the cylinder head and distributor flange have line
marks. If not, make a mark on the cylinder head and flange so as to assemble in the previous position.
Fig.154 Fig.155
——Loosen and remove two M6 ×
20 bolts.
——Remove the distributor.
——Remove the distributor’s “O “seal.
Assembly: ——Insure that the engine is set correctly with No.1 Cylinder at TDC.
——Install new “O” seal.
——Rotate distributor to align the lug with the No. 1 cylinder TDC mark on the distributor flange. Install
the distributor inserting the lug into the camshaft groove.
——Rotate distributor to align the mark on distributor flange with the mark on cylinder head.
——Tighten two bolts to 5.0—7.0Nm.