18
Surround Panel Installation
Complete the venting and gas line installation before
installation of the surround and riser bar.
All Surround Panel fasteners are already installed in
the appropriate locations. Simply remove and use them
to attach the panels together in the same locations. A
10 mm wrench will be required.
R
R
R
R
RISER B
ISER B
ISER B
ISER B
ISER BAR:
AR:
AR:
AR:
AR: The 2” riser bar is used in conjunction with
the standard surround, and is only needed in the event
that the fireplace opening is between 27 1/2” and 29 1/
2” high. The riser bar can be used in any installation if
desired. See fig. 22.
Start with the insert slightly pulled out of the fireplace.
1. If the riser bar is to be used the insert must be lifted
2” off the floor of the fireplace to allow for the riser
bar to fill the space below the bottom grill assembly.
Exception: in raise fireplace installations the riser bar
may extend toward the hearth. See fig. 22.
2. This can be done through the use of the four leveling
legs that are included with the unit. One leveling leg
is threaded through the floor in each corner of the
fireplace.
3. Any other non-combustible material can be used to
lift the unit the necessary 2” for the riser bar.
NOTE: DUE TO THE WEIGHT OF THE SURROUND AND
RISER BAR IT MAY BE NECESSARY TO UTILIZE THE
S
SS
SST
TT
T
TAB
AB
AB
AB
ABIIIIILIZER B
LIZER B
LIZER B
LIZER B
LIZER BAR
AR
AR
AR
AR THAT IS SHIPPED WITH THE UNIT.
THIS STABILIZER ATTACHES TO THE OUTSIDE OF THE
FIREBOX AND WILL BRACE THE UNIT AGAINST THE
FIREPLACE LINTEL PREVENTING THE UNIT FROM
LEANING FORWARD. See figs. 22 and 22A.
4. Lay the four surround panels on the floor backside
up. Using two bolts and washers attach the right
and left upper sections (breastplates) together. See
fig. 23.
5. Attach the left and right leg sections to the breast-
plate assembly using a bolt and washer on each side.
See fig. 24.
6. Four mounting tabs are attached to the back of the
surround panels at the factory. Be sure all four tabs
are in place and secure. See fig. 25.
7. Stand the assembled surround up and gently lift to
the unit. Align the mounting holes on the sides of
the insert with the mounting tabs on the surround.
See fig. 25.
Figure 22A. Mount
the stabilizer bar
using the two
6mm nuts
installed on the
top of the unit.
Stabilizer
Bracket
6 mm nuts
Figure 24.
Attach Breastplates to Legs
Figure 23
Use set screw to adjust alignment
Figure 23. Attach Surround Breastplates
2” Riser
Bar
Bottom Grill
Assembly
Stabilizer
Bracket for use
with raised
fireplaces
Mounting bolts
for stabilizer
bracket
Figure 22. Installing the Stabilizer Bar.
1234
1234
1234
1234
1234
1234
1234
1234
12345
12345
12345
12345
12345
12345
12345
12345
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
Fireplace
Lintel
Raised Fireplace
Содержание GI 450 DV Katahdin
Страница 2: ...2...
Страница 25: ...25 Figure 35 Install Left Side Panel Figure 36 Install Upper Rear Panel...