Jolimark bp-900kll, Руководство пользователя

Страница: 15 / 76

BP-900KII User's Manual
- 9 -
6. Check whether the ribbon is fed through the ribbon guide from left to right and make sure the
ribbon is flat. Turn the ribbon knob as the arrow shown to tighten the ribbon.
7. Hold the lever with your left hand and pull the lever towards the front of printer to make the frame
pole out of the lever slot, and then press the “PUSH
压下
” label on the upper frame, to press the
upper frame down until it lock in place. And then close the upper cover.
Caution: 1. Don't move the print head when the printer is power on, or else, it may damage the
printer. Moreover, don’t touch the print head if the printer has just been recently
used as the print head may be hot.
2. When closing the upper cover, please don’t let it fall down freely, you should hold
the upper cover and close it slowly, or it may hurt you or damage the printer.
Note: 1. When you remove the ribbon cartridge, please refer to the description above, and
then operate in opposite steps.
2. When the print becomes faint, you need to replace the ribbon cartridge. Otherwise,
the print quality would be affected and the print head may be damaged.
3. Please use the Jolimark JMR128/JMR131 ribbon cartridge only. Manufacturer will not
honor warranty when using unauthorized ribbon cartridge.
4. Turn the ribbon knob as the arrow shown.
Projection
Mounting slot
Figure 2-13 Aim the projections at the mounting
Figure 2-14 Fix the ribbon guide