Johnson Controls York YHAU-C, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 180

General chiller information and safety
Introduction
YORK YHAU-C absorption chillers are manufactured to the highest design and construction
standards to ensure high performance, reliability, and adaptability to all types of air conditioning
installations.
This chiller is for air conditioning or cooling a manufacturing process. Use this chiller after installing
the chilled water pump, cooling water pump, cooling tower, steam condensate control valve, valves,
strainers, pressure gauges, thermometers, and so on, according to the water quality information
contained in Maintenance .
About this manual
This manual and any other document supplied with the unit are the property of Johnson Controls,
which reserves all rights. This manual may not be reproduced, in whole or in part, without prior
written authorization from an authorized Johnson Controls representative.
In addition, this manual:
• Includes suggested best working practices and procedures, which are issued for guidance only,
and they do not take precedence over the above stated individual responsibility and/or local
safety regulations.
• Contains all the information required for correct installation and commissioning of the unit,
together with operating and maintenance instructions.
• Should be read thoroughly before attempting to operate or service the unit.
• Contains detailed procedures, including installation, commissioning, and maintenance tasks that
must only be performed by suitably trained and qualified personnel.
The manufacturer will not be liable for any injury of damage caused by incorrect installation,
commissioning, operation, or maintenance resulting from a failure to follow the procedures and
instructions detailed in this manual.
Warranty
Johnson Controls warrants YHAU-C chillers in accordance with the Limited Warranty Engineered
Systems Equipment procedure. Refer to Limited Warranty (Form 50.05-NM2).
Johnson Controls warrants all equipment and materials against defects in workmanship and
materials for a period of 18 months from the date of shipment or 12 months from the date of start-
up, whichever comes first, unless labor or extended warranty has been purchased as part of the
contract.
The warranty is limited to parts only replacement and shipping of any faulty part, or subassembly,
which has failed due to defects in workmanship and materials. All claims must be supported by
evidence that the failure has occurred within the warranty period, and that the unit was operated
within the designed parameters specified.
All warranty claims must specify the unit model, serial number, order number, and run hours/
starts. Model and serial number information is printed on the unit identification plate.
The unit warranty will be void if any modification to the unit is carried out without prior written
approval from Johnson Controls. For warranty purposes, the following conditions must be satisfied:
• The initial start of the unit must be carried out by trained personnel from an authorized Johnson
Controls Field Service Office.
YHAU-C Single Effect Steam-Fired Absorption Chiller 8