Coffeemar
G-250
//
Coffee
MNP116M01GBV00
Date: 09/04/2013 Rev. 1
PAGE 41 OF 95
Fig. 41
The cups are classified in terms of the
abovementioned diameter and divided into:
Cups with a diameter
under top ring (W)
65-67 mm
2.559”–2.638”
67-69 mm
2.638”–2.717”
Cup height (H)
100-104 mm
3.937”-4.094”
Minimum height between
the rims of two adjacently
stacked cups(H1)
2 mm
0.079”
When you load cups for the first time (all storage tubes are empty) proceed as follows:
1.
Check that the cup storage tube closest to the cup dispenser hole is centred above
this hole.
2.
Remove the lid of the cup storage tube assembly
3.
Insert the cups in all tubes except for the tube immediately above the cup dispenser
hole.
4.
If there are now cups present when the power is turned on, this will be detected by the
machine and it will rotate the tube assembly until it finds a tube with cups.
5.
Fill the empty tube with cups.
6.
Press the button located on the cup dispenser to manually drop cups, one by one,
until a cup reaches the product filling position.
7.
Put the cover back on the cup storage tube assembly.
Note:
When the machine is connected to mains and the sensor does not find any
cups, the distributor will rotate the columns
eight positions in a row.
If no cups are
detected in any tube, the message “cups missing” will appear on the display and the
machine will be left out of service.
5.6. Stir-stick loading
Follow the steps below to load stir-sticks in their container.
1.
Remove the stir-stick storage slide counterweight.
2.
Insert a stir-stick bundle, held together with a ribbon in the slide.
3.
Hold the stir-stick bundle with one hand while you cut the lower part and pull the
ribbon upwards.
