78
5-43
5-44
Operation
5.12.2 Anti-skid function
On wheels with
a limited weight, skid specifi cations
may make it impossible to perform a launch at the
normal measuring speed.
This function may be disabled for a single launch:
•
Hold the
Enter
key down while the wheel guard is
lowering.
5.12.3 Weight Unit Toggle Mode
Setting the basic weight unit:
grams.
Select this mode to change the unit of measure of
the weight before or after carrying out a balancing
operation.
•
Select the “*” key until the weight units indicator
fl ashes.
The “oz” indicator will start fl ashing.
The display now equals
Figure 5-43
.
•
Select
Return
.
The weight setting status now calculates weights using
a different unit of measure (from grams to ounces or
from ounces to grams).
The program returns to the main menu.
5.12.4 Dimension Unit Toggle Mode
Setting the basic unit of measure for diameter and
width: inches.
Select this mode to change the unit of measure of
the diameter and width before or after carrying out a
balancing operation.
•
Select the “*” key until the dimensional units
indicator blinks.
The “mm” indicator will start fl ashing.
The display should now appear as shown in
Figure
5-44
.
Note
:
Make sure that all the preset PAX units
have been removed. The operator can
now select the units in steps of 1 mm if
the mm mode has been selected.
•
Select return.
The state of the diameter and width dimension units
will toggle (inch to mm, or mm to inch).
Offset is always measured and shown in millimetres.
The program returns to the main menu.
Содержание MIX-2
Страница 116: ...116 Blank Page ...
Страница 126: ...126 Blank Page ...
Страница 127: ...127 Blank Page ...