JLG 1030P, Руководство по эксплуатации и безопасности

Страница: 24 / 56

SECTION 2 - PREPARATION AND INSPECTION
2-4
3121789
2.3 PRE-START INSPECTION
The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage (oil, fuel, or bat -
tery fluid) or foreign objects. Report any leakage to proper
maintenance personnel.
2. Structure – Inspect the machine structure for dents, dam -
age, weld or parent metal cracks or other discrepancies.
Report this to the proper maintenance personnel.
3. Decals and Placards – Check all for cleanliness and legibil -
ity. Make sure none of the decals and placards are missing.
Make sure all illegible decals and placards are cleaned or
replaced.
4. Operation and Safety Manual
– Make sure a copy of the
Operation and Safety Manual, AEM Safety Manual, and ANSI
Manual of Responsibilities is enclosed in the weather resis -
tant manual storage container.
5. Walk-Around Inspection
– Refer to Section 2.4.
6. Battery
- Charge is required.
7. Hydraulic Oil
- Check the hydraulic oil level. Ensure hydrau -
lic oil is added as required.
8. Function Check - Once the Walk-Around Inspection is com -
plete, perform a function check of all systems in an area free
of overhead and ground level obstructions. Refer to Section
2.5 for more specific instructions.
9. Platform Gate –
Keep gate and surrounding area clean and
unobstructed. Verify the gate closes properly and is not bent
or damaged. Keep gate closed at all times except when
entering/exiting the platform and loading/unloading mate -
rials.
10. Lanyard Attach Points –
JLG Industries, Inc. recommends
personnel in the platform wear a fall/travel restraint system
with a lanyard attached to an authorized lanyard attach
point.
IF THE MACHINE DOES NOT OPERATE PROPERLY, TURN OFF THE MACHINE IMMEDIATELY!
REPORT THE PROBLEM TO THE PROPER MAINTENANCE PERSONNEL. DO NOT OPERATE
THE MACHINE UNTIL IT IS DECLARED SAFE FOR OPERATION.
.
Parent Metal Crack Weld Crack