Jireh STIX, Руководство пользователя

Страница: 27 / 53

PAGE 22 of 47
2. Follow the cable placement zipping the tube closed and closing the cable
management’s cable latch
(Fig. 71)
.
3. Once the cable is placed the entire length of tube, bring the zipper from the
tubes opposite end, meeting at any point in the middle
(Fig. 72)
.
4. When necessary, the two zippers may be opened to allow any cables to exit
the tube anywhere between the
ends
(Fig. 73)
.
4.8.3. Clamp Setup
If the tube becomes disconnected from
the cable management dovetail mount,
follow these instructions to re-attach
the cable management tube and
dovetail mount.
1. Loosen the clamp screw using the
supplied 3 mm hex driver.
2. Slide the clamp around the tube
first and then slide the tube around
the outside of the
cable management dovetail mount
(Fig. 74)
. Align the zipper opening
and the cable management
dovetail mount opening.
3. Slide the clamp over the tube and
cable management dovetail mount
pinching the tube in between
(Fig. 75)
.
4. Tighten the clamp screw
(Fig. 76)
.
Fig. 72
- Zip opposite end
Fig. 73
- Flexibility
Fig. 74
- Slide tube around mount
Fig. 75
- Slide clamp onto mount
Fig. 76
- Tighten clamp screw