e-Save
The fourth screen within the Hybrid Electric Pages App
is the e-Save screen. From this screen, you can specify
the behavior of the e-Save drive mode:
•
Battery Save - Maintains the high voltage State of
Charge at its current level under most driving
scenarios.
NOTE:
The SOC may increase if there is sufficient energy
capture through regenerative braking.
•
Battery Charge - Uses additional power from the gas
engine to increase the high voltage State of Charge,
up to 95% capacity.
NOTE:
For information on jump starting your vehicle,
Charge Settings — If Equipped
The fifth screen within the Hybrid Electric App is the
Charge Setting screen. From this screen, you can select
the rate at which your vehicle charges. Rate selections
1 (low rate of charge) through 5 (high rate of charge)
are available. The lower the selected rate, the longer it
will take for your vehicle to reach a full charge.
The Charge Setting can be adjusted by pressing the “+”
or “-” buttons, and the estimated time until full charge
will update on the right side of the screen to reflect the
selected Charge Setting.
NOTE:
•
The Charge Setting will be saved each time the
vehicle is turned off, then back on again.
•
For information on jump starting your vehicle,
[[REFER: JUMP_START]].
KEYS
KEY FOB
Your vehicle is equipped with a key fob which supports
Passive Entry, Remote Keyless Entry (RKE), Keyless
Enter ‘n Go™ (if equipped), and Remote Start
(if equipped). The key fob allows you to lock or unlock
the doors and swing gate from distances up to approxi-
mately 66 ft (20 m). The key fob does not need to be
pointed at the vehicle to activate the system. The key
fob also contains a mechanical flip key.
NOTE:
•
The key fob’s wireless signal may be blocked if the
key fob is located next to a mobile phone, laptop, or
other electronic device. This may result in poor
performance.
•
With the ignition on and the vehicle moving at
2 mph (4 km/h), all RKE commands are disabled.
WARNING!
Push the Mechanical Key Release Button only with the
key fob facing away from your body, especially your eyes
and objects that may be damaged, such as clothing.
CAUTION!
The electrical components inside of the key fob may
be damaged if the key fob is subjected to strong elec-
trical shocks. In order to ensure complete efficiency
of the electronic devices inside of the key fob, avoid
exposing the key fob to direct sunlight.
e-Save Screen
Key Fob
1 — Mechanical Key Release Button
2 — LED Indicator
3 — Unlock Button
4 — Lock Button
5 — Remote Start Button
6 — Panic Button
GETTING TO KNOW YOUR VEHICLE
31
2
5538906_24_JL_OM_EN_USC_t_E1.pdf 31
5/22/2023 9:02:17 AM
