HARD TOP FRONT PANEL(S)
INSTALLATION
1. Open the header latch inside the vehicle, and the
three L-shaped locks on each panel.
2. Set the right side panel on the windshield frame
with the locating pin in the front receiver mounting
hole followed by the left side panel, making sure
there is no overhang. Also, make sure that the pan-
els are sitting flush with the body.
3. Reinstall the panel(s) using the same steps for
removal in reverse order.
NOTE:
To prevent water leaks, the seals and hard top panels
should be clear of any dust and debris prior to
reinstallation.
REMOVING THE HARD TOP
1. Remove both front panels
2. Open both front doors.
3. Using the provided #50 Torx head driver and
ratchet, remove the two Torx head screws that
secure the hard top at the B-pillar (near the top of
the front doors).
4. Remove the six Torx head screws that secure the
hard top to the vehicle (along the interior bodyside —
three screws on each side) using the #50 Torx head
driver.
5. Open the swing gate all the way to ensure clearance
of the rear window glass. Lift the rear window glass.
6. Locate the wire harness and washer hose on the left
rear inside corner of the vehicle.
Step Three
Step Four
Step Five
Step Six
GETTING TO KNOW YOUR VEHICLE
103
2
5538906_24_JL_OM_EN_USC_t_E1.pdf 103
5/22/2023 9:02:20 AM
