- 09 -
Connection outside Europe:
There are different mains designs around the world. The Sparx 12 may only be operated on the
following power supply systems:
Mains
Sparx 12
2 wires,
1 phase
L
N
L
N
PE
3 wires,
1 phase
L
N
L
L
PE
N
4 wires,
3 phases
L
1
L
2
L
3
N
L
N
PE
ATTENTION:
In Canada, the Sparx 12 may
only be operated in a 2-wire, 1
phase network with a maximum
voltage of 120V!
!
Connection values: Voltage 100-240 V, frequency 50 - 60 Hz, max. power 750 VA
The electrical safety and function of the device can only be guaranteed if it is connected to a properly
installed protective conductor system. It is very important that this basic safety requirement
is met. If in doubt, have the electrical installation checked by a specialist. The manufacturer
cannot be held responsible for damage caused by a missing or interrupted protective conductor
(e.g. electric shock)! Only use the device when it is completely assembled so that no electrical
components can be touched.
(Danger 100-240 V)
If you have observed the listed points, you can plug in the devices or have them connected to
the mains by a specialist.
3.3 Mains connection
ATTENTION: The Sparx 12 can light up immediately if standalone operation is
activated or a DMX signal is present!
!
The Sparx 12 has a powerCON-TRUE1 out power output. Depending on the local conditions,
several devices can be linked by powerCON-TRUE1 in and powerCON-TRUE1 out. Connect a
maximum of two Sparx 12 in a row when using 230V/16A. Use an approved three-core cable
with a cross-section of at least 1.5 mm². Cabling must be done with the original Neutrik coded
plugs. The installation instructions of the manufacturer (www.neutrik.com) and the colour coding
of the cable must be observed.
3.4 Wiring the power feed-through
ATTENTION: Only have it carried out by a specialist!
!
Wire colour
Function
Symbol
Brown
Phase
“L”
Blue
Neutral wire
“N”
Green/Yellow
Protective earth „N“
