JB-Lighting SPARX 12, Руководство по эксплуатации

Страница: 17 / 60

- 17 -
INFO
SOFTWARE VER.
FIXTURE ID
TOT OP. TIME
TEMP BASE LCD ACTUAL
MAX RESET?
TEMP HEAD PCB ACTUAL
MAX RESET?
TEMP HEAD DRV ACTUAL
MAX RESET?
TEMP BASE PS ACTUAL
MAX RESET?
TEMP HEAD LED ACTUAL
MAX RESET?
TEMP HEAD LEDS
TOT BAT CHARGE T.
TOT LAMP TIME
TEMP BASE AIR ACTUAL
MAX RESET?
4.2 FACTORY DEFAULTS - Factory settings
To reset the Sparx 12 to the factory settings, go to the menu item FACTORY DEFAULTS -> LOAD
DEFAULTS. After confirming the security query SURE? by pressing the "ENTER" button for 2
seconds, all parameters are reset to the factory settings.
4.3 USER DEFAULTS - User settings
If the user has set the Sparx 12 in the PERSONALITY menu to their personal settings, these can
be saved and loaded in the USER DEFAULTS menu. In order to prevent unintentional alteration
of the data, you must enter the following password during the saving process: Buttons "ESC
DOWN UP ENTER".
4.4 DMX / NET ADDR - DMX addressing / Artnet addressing / sACN addressing
The DMX addressing can be done either directly in the display. Press the "UP" or "DOWN"
button to set the desired DMX address. The value is confirmed with the "ENTER" key. However,
the DMX addressing can also be done within the menu item DMX / NET ADDR, and there under
DMX ADDRESS.
To set the Artnet address, the menu item ARTNET ADDRESS must be selected in the DMX /
NET ADDR menu. The Artnet address can now be set using the UP / DOWN buttons. The Artnet
address is displayed in the form 000.00.00. This display corresponds to: Net.Subnet.Universum.
The sACN address can then be selected in the DMX / NET ADDR -> sACN ADDRESS menu. The
address can now be set using the UP / DOWN buttons. The sACN address is displayed in the
form 00000.
4.5 PERSONALITY - Personal settings
The PERSONALITY menu is used for personal configuration of the spotlight. Most of these set-
tings are also adjustable via the headlamp control channel. For this purpose, the corresponding
DMX value must be sent for 2 seconds, then the headlight adopts the setting. Exempted here
are the setting of the DMX smoothing these values must be permanently applied, as well as the
setting of the COOLING MODE, this depends on the switch SAFE MODE SWITCH, this is on OFF
the COOLING MODES can be switched directly, this is on ON additionally DIMMER and SHUT-
TER must get the DMX value 0. Only then can be switched.