- 51 -
DMX TEST
This menu item is used to test the DMX input. Use the function keys to select the DMX channel
to be tested. The display shows the incoming value and the Sparx 12 reacts accordingly at the
same time.
INIT PAN TILT
The Sparx 12 is calibrated in the pan/tilt position at the factory. If it loses this calibration, i.e. the
spotlight hits the stop or no longer finds its position or the pan/tilt boards had to be replaced,
it can be re-initialised using this function. This process takes about 10 minutes and ends with a
reset.
DISPLAY CONTRAST
The contrast of the LCD display may change when the temperature is too high. In this menu item
the contrast can be adjusted.
LED TEST
The Sparx 12 checks all LEDs individually to establish whether they are functioning. If an LED is
faulty, this is indicated by an error message.
FUNCTION TEST
This function allows you to test all functions of the Sparx 12 without using a light mixer. The pan/
tilt reset is deactivated in the process.
6. Service
6.1 Service menu
RESET FIXTURE
Upon the “Reset” command, the Sparx 12 will initialise to its initial values. It is the same proce-
dure as after switching on the Sparx 12. If an error message appears in the display, this could
be the first step to correct it.
ERROR LIST
The Sparx 12 stores all occurring errors internally. An error message can have a harmless cause.
If you experience frequent error messages, please contact our authorised dealer or our JB-Light-
ing service department. All error messages are displayed with the respective frequency and can
be deleted.
FINE ADJUST
The FINE ADJUST area is protected by a key combination. Focus, shapers, shaper rotation, pan
and tilt are calibrated at the factory. If there are large deviations in the calibration between the
individual headlights, this can be corrected in the FINE ADJUST menu. For more information
please contact our service.
5.5.5 RDM sensoren IDs
RDM sensor ID
GET
SET
DISCO-
VERY
Note
RDM-Sensoren
Temp Sens Base LCD
✔
✔
Temp Sens Base PS
✔
✔
Temp Sens Base AIR
✔
✔
Temp Sens Head PCB
✔
✔
Temp Sens Head DRV
✔
✔
Temp Sens Head LED
✔
✔
IDENTIFY DEVICE
The RDM command IDENTIFY DEVICE can be called up or deactivated via this menu item.
