Page 4 / 41
Ref doc :
330740F/EN
revision 01
29.09.2015
1
Guidelines for safe use
The European Machinery Directive states that a radio remote control must be considered
both as a control unit and as a safety component for stopping a system. Safe use of a radio
remote control therefore calls for strict compliance of all applicable rules.
For maximum safety
when handling the radio remote control, be sure to carefully observe
the instructions given in this manual.
The operator must be appropriately trained and qualified
for use of the radio remote
control.
On an installation, an emergency stop button which is visible must always be
operational.
When the transmitter is not being used, it must be placed on its charger ; its
emergency stop button is therefore no longer operational. For this reason, it is important to
install the charger so that the transmitter emergency stop button is not visible when the
transmitter is placed on its charger.
The operator must have an uninterrupted view of the manoeuvre which he is
performing
. When the direct field of view is insufficient, the systems controlled must be
equipped with auxiliary devices improving visibility.
When several moving systems are controlled simultaneously, the systems must be equipped
to reduce the consequences of a possible collision.
If all the safety areas are not always visible simultaneously, one of the following startup
modes must be used :
Manual startup using a wired ON pushbutton placed at a location from which all the
safety areas are visible.
Radio-controlled startup by infrared. The IR receiver must also be placed to force the
user to go to a location where all the safety areas are visible.
Never leave the transmitter unattended
in any haphazard location, especially when it is
switched on.
Never leave the transmitter on the ground.
If doing so becomes indispensable, press the
stop palm switch on the transmitter.
If several radio remote controls are used at the same site
, different radio frequencies
should be used, spaced by at least 2 channels (example, ch
annels 5, 7, 9,. ….) of 5 channels
if several systems are operating together within a radius of 10 meters.
When not in use, for safety purposes
, remove the electronic key.
Do not forget to recharge the battery when discharged
.
Do not use the transmitter when it is in charge.
In the event of a malfunction,
immediately shut down the installation by pressing the
emergency stop palm switch on the transmitter.
Ensure your equipment is properly serviced and perform periodic
checks in accordance
with the intensity of use of your equipment.
