Jason International, Inc. •
501.771.4477
Page 9 of 17
Customer Service : 800.255.5766
Copyright © 2013 Jason International.
THe MICROSILK
®
CONTROL BOX
The MicroSilk
®
unit and water level sensor must be
plugged into the proper receptacles for correct operation
of the system. See
Figure 10
for connections: (A) The
power cord for the MicroSilk
®
pump control box must be
plugged into the proper GFCI dedicated circuit for the
system (see note above). (C) The MicroSilk
®
pump’s power
cord will need to be plugged into the control box (B). Refer
to the ELECTRICAL section of this manual for connecting
the pump to the control box. (D) Two-pin terminal for
installation of the water sensor switch to the MicroSilk
control box.
NOTe: This diagram (Figure 10) also applies to 50 Hz,
240v equipment, controls, and power supply systems.
except that the MicroSilk and blower junction box
must be connected into one dedicated 240v, 20 Amp
GFCI circuit.
Figure 10
CONTROL BOX CONNECTIONS (cont.)
SIGNATURe eDITION
MICROSILK
®
-AIRMASSeUR
®
Jason’s Signature Edition MicroSilk
®
-AirMasseur
®
system
is the most advanced bath manufactured by Jason
International, Inc. and features the ultimate in luxury bathing
for the leisure bath industry. The MicroSilk
®
and blower
control boxes must be properly connected for the bath to
function correctly.
THe AIRMASSeUR
®
CONTROL BOX
The blower and ozone sanitation unit, must be plugged
into the proper receptacles for correct operation of the
MicroSilk
®
- AirMasseur
®
system. See
Figure 11
for
connections: Pre-wired power cord from blower (I) and
ozone unit (G) to the control box (H).
THe MICROSILK
®
CONTROL BOX
The MicroSilk
®
unit, keypad, LED light and water level/
temperature sensor must be plugged into the proper
receptacle for correct operation of the MicroSilk
®
-
AirMasseur
®
system.
See Figure 11
for connections:
(A) The junction box for the MicroSilk
®
/blower control
boxes must be connected into a 240v, 20 amp GFCI
dedicated circuit. (C) The MicroSilk
®
pump’s power cord
will need to be plugged into the control box (B). Refer to the
eLeCTRICAL
section of this manual for connecting the
pump to the control box. Eight-pin mini-DIN terminal for
installation of MicroSilk
®
-AirMasseur
®
keypad (F). Six-pin
mini-DIN terminals for the water/temperature sensor (D),
and LED light (E) to the MicroSilk
®
control box.
NOTe: This diagram (Figure 11) also applies to 50 Hz,
240v pumps, controls, and power supply systems.
Figure 11
