Jason International, Inc. •
501.771.4477
Page 11 of 17
Customer Service : 800.255.5766
Copyright © 2013 Jason International.
Signature edition Automatic Purge
Twenty (20) minutes after the control has shut off and the
bath is completely drained, the blower will start again for a
two-minute purge cycle that dries the air channel. Note that
the LCD display will read “PURGE” and begin to countdown
the 10 or 20 minute pause before the purge cycle begins.
The readout will display “PURGE ON” during the purge
cycle. Any time during the pause before the purge cycle
begins, pressing and holding the Blower Speeds icon will
reduce the pause from 20 minutes to 10 minutes. During
the two-minute purge, pressing the “Blower On/Off” icon will
stop the purge.
Signature edition Daily Purge
The daily purge can be activated through the customized
settings of the Signature Edition touchpad. When activated,
the daily purge will start the blower for two-minutes at the
same time every day to dry the air channel. See “Operating
The Signature Edition MicroSilk AirMasseur Touchpad”
section for details on activating this setting.
Filling and Draining
Close the drain and fill the bath with water at least two (2)
inches (50mm) above the jets. The inlet temperature should
not exceed 60°C (140°F) as this could damage the acrylic
surface. When bath is in use, turn the unit Off before draining
the water. The bath unit and its plumbing are designed to
drain after each use whether used as a hydrotherapy bath,
soaking bath, or just taking a shower.
NOTe: If the unit fails to operate, check the breaker
panel to ensure that the circuit breaker is on. Check
the GFCI by testing and resetting it. Also check the
water level in the bath; it must be above the water level
sensor located on the sidewall of the bath for the pump
to operate. If the unit still fails to operate, refer to the
Trouble Shooting Guide section of this manual. If the
unit still fails to operate and is out of warranty, contact
an authorized service technician for repair. If the unit
is within the warranty period, contact JASON Technical
Services at 800-255-5766. DO NOT ATTeMPT TO
ReSOLVe THe PROBLeM.
OPERATING INSTRUCTIONS, FEATURES, AND CONTROLS (cont.)
