Japan Radio Co. JLR-8400, Инструкция по эксплуатации

Страница: 128 / 218

4-80
4.15.14 Setting Sensor Position / CCRP
·
You can set the ship size, CCRP position, and GPS sensor position.
· The CCRP position and GPS position are set on a coordinate system with the center of the ship as
the point where the axes cross.
· Set the ship size (ship length and width), and set the CCRP position and GPS sensor position.
· The set CCRP position can be output to externally connected equipment. For output, refer to "4.15.4.1
Setting transmission ", and select "PJRC,SAP,GP" or "POS" as the output sentence.
To output to external equipment, the equipment must have CCRP send / receive functionality.
·
CCRP cannot be set from a sub-display. Set CCRP from the main display.
1. Refer to "4.15.1 Changing to a maintenance mode"
and display the maintenance menu.
2. Press the key to select "CCRP"
and press the key.
3. Press the key to select the ship size ("BEAM", "LENGTH"), and enter the shi size.
4. Press the key to select the sensor position ("SENSOR X/Y/Z"), and enter the sensor
position
5. Press the key to select the CCRP position ("CCRP X/Y/Z"), and enter the CCRP position
The CCRP position can be received. If the set position and received position differ, a pop up alert
will occur, so please perform the settings again.
4.15.15 Calculating Trip Distance
Trip distance is calculable from a ship speed and
elapsed time.
Two trip is simultaneously calculable.
In order to do trip calculation, it is necessary to select a
distance screen by screen selection.
1. Press the key to sect "START" of TRIP1 or "START" of TRIP2 and press the key.
2. "RUN" blinks and calculate trip.
3. Press the key to select "END" and press the key.
Trip distance is displayed until it selects "START" again.
Procedure
Y
X
Origin (0,0,0)
Z
CCRP (X,Y,Z)
Sensor (X,Y,Z)
Procedure
Trip will be cleared when a power is turned OFF.
Supplement