Japan Radio Co. JLR-8400, Инструкция по эксплуатации

Страница: 126 / 218

4-78
4.15.10 Performing a Demo
Through a demonstration, display and external output are enabled in the same way as the actual
equipment operation.
The following demo types can be set.
1) STATIC:
Remains stationary.
2) STRAIGHT: Goes in straight lines. Set the speed and direction.
3) RIGHT:
Turns right. Set the speed and turn radius.
4) LEFT: Turns left. Set the speed and turn radius.
5) ROUTE: Performs selected route
6) AUTO: Moves in set direction a set distance from set position.
1. Refer to "4.15.1 Changing to a maintenance mode" and display the maintenance menu.
2. Press the key to select "DEMO MODE" and "DEMO TYPE" in order.
3. Press the key to select "DEMO TYPE" and press the key.
4. Press the key to enter the unit
5. Enter "DATE", "TIME", "LATITUDE" and "LONGITUDE".
6. Press the key to select "DEMO MODE." Set "START."
4.15.11 Setting the Sub Display
The display unit can be used as SUB-Display
If the display set to sub display, it can not be set to GPS sensor unit
If you set to "MAIN", the display unit can be used as MAIN-Display
1. Refer to "4.15.1 Changing to a maintenance mode" and display the maintenance menu.
2. Press the key to select "MAIN/SUB" and press the key.
3. Press the key to select "SUBSTITUTE" and press the key.
4. When the following popup menu is displayed, press “YES”.
5. The display unit is restart automatically
Procedure
Procedure
When the demo is being performed, [S] will blink at the bottom of the screen.
To stop the demo, set "END" to "DEMO MODE" or turn the power off.
Supplement
ARE YOU SURE
？
OK CANCEL
When master reset of "DISPLAY" is performed, the setting is reset to that at the factory
delivery and a receiver selection screen is displayed. Select a sensor that is connected.
For the selection method, refer to "4.2.1 Turning the Unit On".
Supplement