Japan Radio Co. JLR-8400, Инструкция по эксплуатации

Страница: 119 / 218

4-71
When the "SEND" or "RECEIVE" of data IN/OUT1 or data IN/OUT2 is set and one port is
set, the other port is also set concurrently. The message that is shown below is displayed to
prevent the unintentional setting of the other port. When setting a port, select “YES”. If “NO”
is selected, the port is not set.
2) Selecting JRC
4. Select an output cycle by using and set an output cycle.
A cycle can be selected only 4 seconds and if OFF is selected, the sentence is not output.
The JRC format can not be select version, bit rate and sentence.
The bit rate is fixed 1200bps.
3) Selecting IEC
For IEC, there is no need to select VERSION.
4. Select “SEND” from “DATA IN/OUT” by using .
5. Select an output sentence by using and set an output cycle.
The cycle can be selected within the range from 1 second to 9 seconds and when OFF is
selected, the sentence is not output.
6. Return control to the BIT RATE selection screen and select BIT RATE by using .
Available bit rates are “4800”, “9600”, “19200”, and “38400”.
7. Select a talker of the sentence in "TALKER SELECT" by using .
To output with the talker that was received from the sensor, select
“
RECEIVED
”
.
To output the talker with "GP", select "FIXED GP".
Supplement