Using a 3/4” wrench and crescent wrench, follow the 1/2” Flare Connector with Required O-Ring Guidelines in
Section E
and assemble coupling (VHPR125) with
O-ring (VHPR120) to the end of a stainless steel line as shown below.
IS275-17L
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Section M - Page 1/2
Section M
Auto Drain Kit Installation & Assembly
Section M
1
NOTE: Only one auto drain kit per each pump system.
The auto drain kit should be installed at the end of a run preferably the furthest from the pump.
Care should be taken to ensure that water that drains from the end of this kit is directed to a location that will not cause slipping,
mold issues, wet bedding, or feed contamination.
Using (2) 3/4” wrenches, follow the PTFE Tape & Tightening Guidelines in
Section E
to assemble adapter (VHPR123) to coupling installed in
Step 1
as shown
below.
VHPR125
- Coupling
VHPR123
- Adapter
1/2” Female Flare at
End of a Stainless Steel Line
VHPR120
O-Ring
PTFE
Tape
2
Using a 3/4” wrench and crescent wrench, follow the 1/2” Flare Connector with Required O-Ring Guidelines in
Section E
and assemble union (VHPR129) with
O-ring (VHPR120) to the end of a stainless steel line as shown below.
3
Using (2) 3/4” wrenches, follow the PTFE Tape & Tightening Guidelines in
Section E
to assemble ball valve (VHPR163) to coupling installed in
Step 3
as shown
below.
VHPR129
- Union
VHPR163
- 2000 psi Ball Valve
VHPR120
O-Ring
PTFE
Tape
4
If system will be winterized with RV antifreeze, proceed to Step 3 as a 2000 psi Ball Valve (VHPR163) will need to be
installed between the end of the line and the Auto Drain Kit.
If system will NOT be winterized with RV antifreeze proceed to Step 7.
