IS275-17L
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Section O - Page 1/1
Section O
Flushing System
Section O
Filtration System Set Up for System Flushing
Assemble and install the 20 Micron Filter and housing as shown below. (If o-ring is dry, lubricate with a small amount of petroleum jelly.) Filter housings have a
positive thread stop, use filter wrench and DO NOT OVER TIGHTEN.
The remaining housings WITHOUT filters are installed at this time.
Flushing System
Open water valve/s and allow filter system to fill, then power pump and motor.
Observe location furthest from pump. Once water starts to flow from that location let system run at least an additional 7-10 minutes.
Proceed to
Section P
.
O-Ring
Filter
Housing
20
Micron
Filter
20
MICRON
REPLACEMENT
FILTER
5
MICRON
REPLACEMENT
FILTER
1
MICRON
REPLACEMENT
FILTER
O-Ring
Filter
Housing
NO
Filter
O-Ring
Filter
Housing
NO
Filter
NOTICE: ---- DO NOT FLUSH SYSTEM WITH NOZZLES INSTALLED ----