Jacuzzi sasha, Использование и обслуживание

Страница: 54 / 168

54
Alarms
Connection to the alarm circuit must be carried out at the installation stage and in compliance
with the warnings detailed in the installation manual.
■
When this key is pressed (for approximately 1 second), it begins to flash and the alarm
indicator is immediately activated (alarms, buzzers, lamps, etc.): this will continue until
the key is pressed again.
ù
- Activation of this function interrupts all other functions in progress (except scale removal cycle).
-The alarm function is even available when the display is locked (see the relative chapter).
Functions associated with display lock
The display lock activates the following modes of use:
- Light synchronization
The colour sequence will be the same for all Sasha modules (hammam, sauna, shower).
- Tepidarium, Hammam, Calidarium
The duration of each of these programmes is always 45 minutes; a 3 minute pause follows
before the function is automatically activated for a further 45 minutes, again, another 3
minute pause follows and so forth, for the following 12 hours.
■
Ensure that no function is in progress and that the display that you wish to lock is in
"stand-by" mode (only ON/OFF key lights up white).
■
Press the key to the left of the ON/OFF key and within 3 seconds, the key to the right:
the display will illuminate and the ON/OFF key will begin to briefly flash.
■
At this point select the desired program.
WARNING: perform the following procedure if the Jacuzzi® remote control system has
been installed: press the key of the program selected, wait for it to go dim and press
again within 20 seconds.
■
To deactivate the function , press the “ON/OFF” key and within 3 seconds, the "alarm"
key (this operation must be performed on the same display used to set the lock).
ù
- The lock only effects the display to which the lock was applied.
- Once the display has been locked, no other programmes aside from the one selected may be
used; the sound system and alarm are however still available; if activated, the alarm interrupts
the active programme; the display is still locked regardless whether the alarm is activated or
the programme in progress ends on its own.
- If a programme is activated via the Jacuzzi® remote control system (where installed), the
relative display is locked and remains this way until terminations of the programme (in this
case, light synchronization be carried out via the remote control system).
However, if light synchronization is the only function activated via the remote control
system, the display will not be locked.
+
instructions