Jacuzzi sasha, Использование и обслуживание

Страница: 37 / 168

37
F
irstly, you must switch on the heater for approximately 45 minutes before a session,
so that the applicable area, the walls and benches reach a comfortable temperature
thanks to the heating up of the air.
ù
When switching on the heater for the first time, you may note that the heat emits residue,
resulting from the manufacture of the heater itself: you must simply ventilate the area before
using using the sauna.
■
Before a bio sauna and/or a Roman sauna session, check that there is a sufficient
amount of water in the steamer tank; if it requires filling, fill it up, leaving 10 cm from its
opening.
E
If, during bio sauna or Roman sauna programmes, the "water pitcher" key
lights up on the display, this indicates that the tank is empty and the steamer
is off (the heater under the stones still remains on). In order to continue using
programmes, wait at least 5 minutes, until the heating element has sufficient
time to cool down, fill up the tank and re-activate the programme by pressing
the "water pitcher" key a second time.
■
If an automatic water filling tank (S) is installed, instead of checking the steamer water
level, check that the water supply system and/or the tap (R) are open.
Given that the area's micro climate is regulated by the convection exchange between the
fresh air that enters via the underside of the heater and the air within the sauna (downwards
to upwards direction of heat)
ensure that ventilation is present by opening the small
window on the wall, under the highest bench. Also check that the hole in the ground,
behind the heater, is not obstructed.
■
Turn on the main switch: the system will enter into "stand-by" mode and the ON/OFF
display key will light up white.
■
Press the ON/OFF key: it will light up blue and the keys relative to the programmes and
the alarm key will simultaneously light up: the display is ready to receive instructions.
NOTE:
- This mode lasts approximately one minute, after this time, if no key has been pressed, the
system reverts to "stand-by" mode.
- The activation of any key is indicated by an acoustic signal.
- If an audio kit is installed (optional), the keys relative to the audio system , will also light up
on on the display.
■
Select one of the three programmes and activate it by pressing one of the indicated
keys (once pressed, the key will turn blue):
WARNING: perform the following procedure if the Jacuzzi® remote control system has
been installed: press the key of the program selected, wait for it to go dim and press
again within 20 seconds.
- Bio sauna (the "water pitcher" key lights up and an acoustic signal sounds: check that there
is water in the steamer and re-press the "water pitcher" key; if you do not press the key, the
steamer will not be activated and the programme will be carried out in "dry run" mode.).
- Roman Sauna (the "water pitcher" key lights up and an acoustic signal sounds: check that
there is water in the steamer and re-press the "water pitcher" key; if you do not press the key, the
steamer will not be activated and the programme will be carried out in "dry run" mode.).
- Finnish sauna
preliminary operations
programme
activation
H
2
O
S
R
each programme
can last 6 or 12 hours
(the duration is
decided at the
installation stage,
using the relevant
switch; refer to the
relative manual).