6
J-600 ELECTRIC
CHAPTER 2 - ASSEMBLING
Mouting the sprayer to the tractor
∙
Remove or pull the tractor’s drawbar aside.
∙
Mount the sprayer to the tractor’s three-point sus-
pension and level it as shown in the figure beside.
tractor’s drawbar
∙
Adjust the tractor’s hydraulic lift lever so that the
sprayer is not raised too high.
h
h
height adjustment
∙
Adjust the PTO shaft. If necessary, cut the male
and female tubes so that, after connecting the
sprayer, it has the overlaps recommended in the
figure beside.
ATTENTION!
Before cutting the tubes, check for all possibilities of movement of the sprayer on the lift
arms and third point.
Make sure the hitch pins locks are correctly installed.
For instructions in detail, refer to the section MAINTENANCE - PTO SHAFT.
A
Note: Align the forks as shown by “A”.
+/- 2 in
+/- 2 in