Jackle ProPuls 320 Compact, Руководство по эксплуатации

Страница: 65 / 76

ProPuls 320C
Operating manual Page 61
Error number Error description and possible diagnosis
E5.0 MAG PROGRAMS MISSING
Internal software error
- Contact JÄCKLE customer service
This error is shown only on the display, but not saved in the error memory.
Delete this error by switching the unit off and on again.
E5.1 WELDING PROGRAMS MIG PULSE NOT AVAILABLE
Internal software error
- Contact JÄCKLE customer service
This error is shown only on the display, but not saved in the error memory.
Delete this error by switching the unit off and on again.
E5.2 Not used
E5.3 ELECTRODE PROGRAMS MISSING
Internal software error
- Contact JÄCKLE customer service
This error is shown only on the display, but not saved in the error memory.
Delete this error by switching the unit off and on again.
E5.4 TIG PROGRAMS MISSING
Internal software error
- Contact JÄCKLE customer service
This error is shown only on the display, but not saved in the error memory.
Delete this error by switching the unit off and on again.
E5.5 MAG MAN. PROGRAMS MISSING (MAG manual programs missing)
Internal software error
- Contact JÄCKLE customer service
This error is shown only on the display, but not saved in the error memory.
Delete this error by switching the unit off and on again.
E6.0 WF HOUSING CAN communication faulty (Wire feeder communication faulty)
- Contact JÄCKLE customer service
Delete this error by switching the unit off and on again.
E6.1 ROBOT INTERFACE communication faulty
This error is shown only on the display, but not saved in the error memory.
Delete this error by switching the unit off and on again.
E6.2 TORCH DISPLAY communication faulty
This error is shown only on the display, but not saved in the error memory.
Delete this error by switching the unit off and on again.
E7.0 REMOTE error
An error is detected with the remote control.
- wrong remote control connected
- cable connection faulty
- Contact JÄCKLE customer service
If a functioning remote control is connected, the error is rectified on its own.
Delete this error by switching the unit off and on again.
AUT ADJ
Power Limit
This alarm occurs if the power limit value is exceeded. The alarm is shown every 1.5
seconds alternating along with the standard display. Nevertheless, the machine
continues to weld with a limited level of power whilst adhering to the values indicated on
the rating plate.