Jackle ProPuls 320 Compact, Руководство по эксплуатации

Страница: 49 / 76

ProPuls 320C
Operating manual Page 45
16.10 Gas test / 11 wire inch
By pressing the key GAS TEST, the gas valve opens and the shielding gas flow for a maximum
duration of 15 seconds. Alternatively, the key can be pressed again in order to end the
procedure.
If the button WIRE INCH is pressed, the wire feeds without voltage or gas.
16.12 Enter/OK - JOBSTORE
With the button ENTER / OK, all entries or queries can be confirmed.
JOBSTORE / call up - manage job memory
Save JOB:
When the optimum welding parameters for your welding task are found, these can be saved under JOB.
Press and hold the button JOBSTORE (pos. 12) for 3 seconds.
The first available space for saving appears in the display, e.g. JOB 003.
You can now save in space no. 3, or select another available space by turning on the left dial (pos. 2). In order to
save the data, press the button JOBSTORE again (pos. 12). The job is now stored.
Overwrite JOB:
If you would like to overwrite a JOB, first set the new parameters on the machine.
Press the button JOBSTORE (pos. 12) for 3 seconds.
The first available space for saving appears in the display. (e.g. JOB 004).
Now you can select the JOB to be overwritten with the left dial (pos. 2), e.g. JOB 002.
Now, press the JOBSTORE button briefly (pos. 12).
A confirmation prompt appears asking if you would like to overwrite this JOB.
If YES, press the special function button 1 under the word OK. The parameters are now saved in this JOB.
If NO, press the special function button 2 under the word DELETE. The procedure is cancelled. Leave the JOB
MENU with the button MODE/MATERIAL (pos. 5).
Select JOB:
If the mode JOB is no longer active, press the button MODE/MATERIAL (pos. 5) until the welding process is
displayed. Now, turn the left dial (pos. 2) until the arrow points to the word JOB. Select with the button ENTER /
OK (pos. 12).
In the upper displays, JOB and 003 is shown (for example).
If you have already saved several JOBs, you can select the individual JOBs with the right dial (pos. 5). The JOB
shown in the right display is always active.
The set parameters for this JOB are shown in the display.
Leave JOB:
In order to leave the JOB mode, you have 2 possibilities:
- 1. Press and hold the JOBSTORE button for 3 seconds.
- 2. Press the MODE button and select another welding process, e.g. MIG PULSE
16.13 Special function button 2
Special
function
button 2
With this button, special functions are possible.
An exact description can be found near the respective functions.
TEST