Jabiru Aircraft
Pty Ptd
Aircraft Service Manual
Jabiru J230-C
REVISION
0
Dated : Feb 2006
Issued By: RAS
Page: 79 of 171
L:\files\Technical_manuals\J230_J430\J230.J430_Work_files\J230-C_Tech_Rev_1.doc
Print Date: 14/01/2009 4:41:00 PM
7.3
CONTROL CABLES
Control Cables are of the enclosed push-pull type, fitted with spherical bearings at both
ends.
To operate, the outer cover of the cable must be clamped firmly at each end.
7.3.1
CONTROL CABLE REMOVAL
1.
Unbolt the connections (rod end bearings) at either ends of the cable.
2.
Unbolt the clamps at either end of the cable.
3.
Where required, remove any ties etc used to restrain the cables in the aircraft.
4.
Tie a string or light wire to one end of the cable.
5.
Draw the cable out of the aircraft, leaving the string/wire in place to allow
installation of a replacement part.
7.3.2
CONTROL CABLE INSPECTION & REPAIR
Repair of control cables is limited to the installation of new parts.
7.3.3
CONTROL CABLE INSTALLATION
Installation procedure is the opposite of removal procedure outlined above.
7.4
AILERONS
Ailerons comprise a moulded and bonded monocoque structure embodying a composite
control horn at the outboard end.
7.4.1
AILERON REMOVAL & INSTALLATION
1.
Unbolt cable from aileron control arm.
2.
Loosen screws in hinge pin retainers and lift hinge pin retainer away from the hinge
pin. It is not necessary to completely remove these parts.
3.
Remove hinge pins.
4.
Remove aileron.
5.
Reverse the preceding steps for installation.
7.4.2
AILERON INSPECTION & REPAIR
Inspect ailerons for any signs of delamination or cracking. Pay particular attention to the
Control Horn and hinges and their surrounding areas.
Repairs must be referred to JABIRU AIRCRAFT Pty Ltd or our approved local agent.
