Jabiru Aircraft
Pty Ptd
Aircraft Service Manual
Jabiru J230-C
REVISION
0
Dated : Feb 2006
Issued By: RAS
Page: 22 of 171
L:\files\Technical_manuals\J230_J430\J230.J430_Work_files\J230-C_Tech_Rev_1.doc
Print Date: 14/01/2009 4:41:00 PM
Ensure that the Master and Ignition Switches are OFF!
7.
Install spark plugs and connect leads.
8.
Seal exhaust pipes. Attach a red streamer to each. DO NOT seal fuel tank
breathers.
9.
Place protective covers over Pitot tube, static source vents, air vents and openings
in engine cowl to prevent the entry of foreign material or beings (especially wasps).
10.
Attach a warning placard to the propeller stating that vents and breathers have
been sealed. The engine must not be started with the seals in place.
11.
Every 7 days the propeller should be rotated through 5 revolutions without running
the engine – leave propeller in the horizontal position.
CAUTION
Ensure that the Master and Ignition Switches are OFF!
3.1.10
INSPECTION DURING STORAGE
1.
Generally inspect airframe and clean as necessary.
2.
Inspect the interior of at least one cylinder through the spark plug hole for corrosion
at least once a month.
3.
If, at the end of the 90 day period, the aircraft is to be continued in non-operational
storage – repeat Steps 1-13 above (most will only need to be checked).
3.1.11
RETURNING AIRCRAFT TO SERVICE
After temporary storage, the procedures for returning the aircraft to service are as follows:
1.
Remove aircraft from blocks and check tyres for proper inflation.
2.
Check battery and install.
3.
Check carburettor air filter and service if necessary.
4.
Remove warning placard from propeller.
5.
Remove materials used to cover openings.
6.
Remove, clean and gap spark plugs.
7.
While spark plugs are removed, rotate propeller using the starter motor for several
revolutions to clear excess preservative oil from cylinders.
CAUTION
Ensure that the Master and Ignition Switches are OFF!
