Jabiru Aircraft
Pty Ptd
Aircraft Service Manual
Jabiru J230-C
REVISION
0
Dated : Feb 2006
Issued By: RAS
Page: 103 of 171
L:\files\Technical_manuals\J230_J430\J230.J430_Work_files\J230-C_Tech_Rev_1.doc
Print Date: 14/01/2009 4:41:00 PM
10.5 RIGGING
1.
To establish the neutral position, raise the nose wheel off the ground by leaning
down on the horizontal stabiliser.
2.
Allow the nose wheel (and therefore the rudder pedals) to centralise.
3.
Align the rudder 5mm to the right at the top of the rudder when referenced to the
lower lip of the fin.
4.
Adjust the rod ends on the cable so that the hole in the rear rod end aligns with the
hole in the control horn.
5.
Fit bolt, nut and washers.
6.
Scribe a line from the centre of the Rudder trailing edge onto the Fuselage.
Displace the Right Rudder Pedal to the Rudder Pedal Stop. Measure the Rudder
displacement at the Rudder trailing edge with reference to the previously scribed
line. It should be 98mm +/- 2mm.
7.
Repeat Step 6 for Left Pedal and adjust Rudder Pedal Stops as required.
WARNING
The Rudder Pedal Stops should engage – NOT the Control Surface Stops on the tail.
DO NOT move the Cable Anchor Points or adjust control surface stops – These are
factory set.
