Remote Control System TT801 – User Guide
MU-TT801-AN rev.6 September 2009
35
CMD ONLY commands (All AR6xx or RT6xx
for function without dual code sequence
)
The following figure sums up the procedure to perform:
TRANSMIT SETTINGS
TYPE : AR6xx
TRANSMIT TYPE :
CMD ONLY
CODE CMD : 04C1
COMMAND : RELEASE
SCROLL = CHOICE
ENTER = VALID
Step 1
Step 3
Step 4
Step 2
RECEIVE SETTINGS
FT0 : MONO 12.0 kHz
RANGING :
DISTANCE
SCROLL = CHOICE
ENTER = VALID
Step 5
Step 6
The access to the ‘Immediate’ settings sub-menus is allowed by pressing
1
key in the menu
TX / RX settings
.
The TRANSMIT SETTINGS display opens.
To configure the various parameters, perform the following procedure:
Step Action
1.
Select the type (
TYPE
) of the instrument to be actuated (All AR6xx or some RT6xx)
using
SCROLL
key and confirm the selection by pressing
ENTER
key.
The
TRANSMIT Type
is
CMD ONLY
.
2.
Select the type of transmission (
TRANSMIT TYPE
), according to individual built sheet of
the beacon:
•
With AR6xx no other choice than
CMD ONLY
.
•
With RT6xx, if function is to be activated by a single direct word sequence,
select
CMD ONLY
by using
SCROLL
key.
Then confirm the selection by pressing
ENTER
key.
3.
Enter the hexadecimal
code (
CODE CMD
) using the alphanumerical keys and confirm
by pressing
ENTER
key.
4.
Indicate to the TT801 which type of command code will be sent to the beacon
•
For RT6xx: Release, Pinger ON, Telemetry (Diagnostic), Other CMD
•
For AR6xx: Release or Other CMD (for INT/Ranging).
Selection is made with
SCROLL
key and confirmation with
ENTER
key.
The RECEIVE SETTINGS display opens, according to the command type.
5.
Configure the
FT0
receiver of TT801:
•
The receive type is
MONO
only (No other choice). Press ENTER key to
confirm.
•
Choose the
FT0
frequency (8 to 16 kHz) by using the
SCROLL
key. Press
ENTER
key to confirm.
Procedure
Procedure
Содержание TT801
Страница 1: ...TT801 Remote Control System User Guide...
Страница 2: ......
