Remote Control System TT801 – User Guide
MU-TT801-AN rev.6 September 2009
28
Commands with FSK transmission
The user can configure a FSK command for the transmission; in this case, the following
parameters have to be set:
•
The TYPE: RT6xx, AR6xx, AR7xx, AR8xx or RT8xx, AR9xx or RT9xx
•
The TRANSMIT TYPE: ARM + CMD (for RT6xx, AR7xx, AR8xx or RT8xx, AR9xx
or RT9xx) or CMD ONLY (RT6xx and only for AR6xx)
Note
Each command code for RT6xx unit can be individually configured with
CMD only
sequence or
ARM & CMD
sequence. If the
ARM & CMD
sequence is required, the
command code, mentioned on the RT6xx built sheet, is followed by the
(W)
label.
•
The CODE ARM (only for ARM + CMD sequence) and then CMD: these are the
hexadecimal ARM and COMMAND codes of the commanded function to initiate
•
The type of command code to be sent to the beacon:
For RT8xx, AR8xx, RT9xx, AR9xx: Release, R Pinger, Pinger ON,
Telemetry (Diagnostic), Other CMD (other function)
For RT6xx: Release, Pinger ON, Telemetry (Diagnostic), Other CMD (other
function)
For AR7xx: Release
For AR6xx: Release, other CMD (for RANGING/INT)
The type of reception parameters to configure depends on the type of transmission
parameters. See Table 4, Table 5, or Table 6 for the correspondence.
Reception
Parameters
Содержание TT801
Страница 1: ...TT801 Remote Control System User Guide...
Страница 2: ......
