IXIA BreakingPoint 20, Руководство по установке

Страница: 46 / 65

BreakingPoint 20 Installation Guide 35 BreakingPoint Systems Inc. © 2005-2015
5 System Configuration
This section covers:
• Initial Configuration
• Factory Revert
Initial Configuration
During an initial configuration, you will set up the IP address, netmask, and gateway for the
BreakingPoint 20. Additionally, during this process, you will create a user account that will be used
to log into the Control Center.
Management ports must be connected via a serial or Ethernet connection to your network. For a
serial connection, use 115,200 8N1 on your terminal application. For an Ethernet connection, the
BreakingPoint 20 will attempt to obtain a DHCP address; if it cannot acquire an address, it will use
the BreakingPoint 20’s default settings: IP address 10.10.10.10, netmask 255.255.255.0 and default
gateway 10.10.10.1.
When you first access the system, BreakingPoint 20 will guide you through the initial
configuration.
To start the initial configuration:
1. Accept the end user license agreement.
2. Enter a fully qualified domain name in the FQDN field.
3. Enter the IP address you want to assign to your BreakingPoint 20 in the IP Address field.
4. Enter a netmask in the Netmask field.
5. Enter the gateway address in the Gateway field.
6. Enter the primary DNS IP address in the Primary DNS field.
7. Enter the secondary DNS IP address in the Secondary DNS field.
8. Enter the tertiary DNS IP address in the Tertiary DNS field.
9. Tab to Next and press the Enter key.
10. Enter your user name in the Username field.
11. Enter your name in the Name field.
12. Enter your email address in the Email field.
13. Enter your password in the Password field.
14. Re-enter your password in the Confirm Password field.
15. Tab to Finish and press the Enter key. You will receive a message that the system is completing
the configuration. Wait for the configuration process to complete.
16. To access the Control Center, enter the IP address you used in step
3
into the URL bar of your
browser.
Note:
After upgrading or reverting to any release of the BreakingPoint 20, you must clear your
cache and refresh your browser.
17. Click the Start BreakingPoint Systems Control Center button on the Start Page.