IXIA BreakingPoint 20, Руководство по установке

Страница: 20 / 65

BreakingPoint 20 Installation Guide 9 BreakingPoint Systems Inc. © 2005-2015
To configure the BreakingPoint device using Telnet:
1. Open a telnet client (e.g., PuTTy, AlphaCom, etc.).
2. Telnet to the following host address: 10.10.10.10.
3. Specify your terminal emulation preference (e.g., ansi, xterm) at the prompt and press
Enter
.
4. Specify the following information for your BreakingPoint device in the Network Information
box:
• DHCP Enable/Disable
Note:
If DHCP is disabled, users will be able to configure additional system routes from the
BreakingPoint Control Center. If DHCP is enabled, the Routes area in the
BreakingPoint Control Center will be disabled.
• DHCP Hostname
• IP Address
• Netmask
• Gateway
5. Select
Next
.
6. Enter the login ID for the user account at the prompt.
Note:
The login ID must use alphanumeric characters and consist of 1-15 characters. The first
character of the login ID must be a letter. Login IDs cannot solely consist of numbers.
The login ID cannot be changed once it has been created.
7. Enter the password that will be used for the user account at the prompt.
Note:
The password can consist of up to 15 alphanumeric and/or special characters.
The system will disconnect while the new network settings are applied and your account is created.
Document the network IP address and user account information. You will need this information to
access and log into the BreakingPoint Control Center. You may create additional accounts through
the Administration page in the BreakingPoint Control Center.
Text Console
This section will describe how to configure the host address, netmask, and gateway for the
BreakingPoint device using a text console.
To configure the BreakingPoint device using a text console:
1. Open a terminal emulation client (e.g., HyperTerminal).
2. Connect to the BPS Management serial port using the following settings:
• Baud Rate: 115200 bps
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: None