IXIA BreakingPoint 20, Руководство по установке

Страница: 31 / 65

Task 8: Creating a Network Neighborhood
BreakingPoint 20 Installation Guide 20 BreakingPoint Systems Inc. © 2005-2015
13. Do one of the following:
• Select
Host
from the
Type
dropdown menu to use one MAC address per host.
• Select
Virtual Router
from the
Type
dropdown menu to use one MAC address for all hosts,
and enter an IP address for the virtual router in the
Router IP Address
field.
Note:
If an IPv6 router is present, the BreakingPoint device will generate at least one global
address. You can discover the automatically generated IPv6 address via the SSH/telnet/serial
interface, using the networkInfo command.
14. Enter an Ethernet address in the
Ethernet Address
field. Use the format xx:xx:xx:xx, where
x is a valid hexadecimal value.
15. Enable or disable the
Use Address Range
option.
16. Enter a range of IP addresses using the
Minimum IP Address
and
Maximum IP Address
fields. Use the format x.x.x.x, where x is a number between 0-255.
Note:
If
Use Address Range
is disabled, you only need to enter an IP address in the
Minimum IP Address
field. The system will only use one IP address for the entire
subnet.
17. Click the
Add Subnet
button.
18. Click the
Save Network
button.
Adding a Test Interface
By default, the system provides you with four transmitting and/or receiving interfaces and one
external interface (for SSL testing). So, if you have a two blade chassis, you will need to add
additional interfaces to your Network Neighborhood.
Each test interface in the Network Neighborhood corresponds to a data port on the chassis. When
you add an interface to a Network Neigborhood, the system will automatically number the interface
based on the order in which it was added.
If you delete any of the interfaces, the system will automatically resequence the interfaces. The
succeeding interfaces (following the deleted interface) will be renumbered to the preceding
interface’s value (e.g., ‘6’ will become ‘5’).
Note:
There can be up to eight test interfaces in a Network Neighborhood and one external
interface.
To add a test interface to a Network Neighborhood:
1. Select
Control Center > Network Neighborhood
from the BreakingPoint Control Center
Menu bar.
2. Select a Network Neighborhood from the
Network Neighborhoods
list.
3. Click the
Add New Interface (‘+’)
button.
Note:
The interface will contain one domain with the default subnet.