IXIA BreakingPoint 20, Руководство по установке

Страница: 19 / 65

Task 1: Installing the BreakingPoint Device
BreakingPoint 20 Installation Guide 8 BreakingPoint Systems Inc. © 2005-2015
Task 1: Installing the BreakingPoint Device
This section will briefly describe how to set up the BreakingPoint device.
To set up the BreakingPoint device:
1. Secure the chassis into an equipment rack. For more information on mounting the chassis, see
the section
Mounting the BreakingPoint Storm into an Equipment Rack on page 32
.
Note:
The chassis must be close enough to the device under test so that you can connect cables
from the appliance to the device under tes
2. Insert the system controller into the module above the power tray. For more information on
installing the system controller, see the section
Installing the System Controller on page
34
.
3. Insert the blade(s) into the top two modules. For more information on installing the blade(s), see
the section
Installing the Blade on page 34
.
4. Power the system. For more information on powering the system, see the section
Powering the
System on page 35
.
5. Connect the device under test to the BreakingPoint device. For more information on connecting a
device under test to the BreakingPoint device, see the section
Connecting a Device Under
Test to the BreakingPoint Storm on page 35
.
Task 2: Configuring the BreakingPoint Device
You will need to use either a telnet client or text console in order to configure the network settings
for the BreakingPoint device. The following sections provide instructions for configuration through
a telnet client or a text console.
Figure 2-1:
Network Information Box
Telnet
This section will describe how to configure the host address, netmask, and gateway for the
BreakingPoint device using either a telnet client or a text console.